Language ： 
Kingshine plast
專(zhuān)業(yè)生產(chǎn)PVC片板材擠出機(jī)
specialize at pvc sheet board extrude
Hot Line
13814297981
Scan pays attention
Jiangsu Kingshine
Instructions
Turbine screen type, air and water double cooling plastic grinder, its complete set of components, fan diffusion cyclone aggregator, electrical control cabinet.
1. The grinder is screen type (by blade, tooth plate) its advantage is that the blade screen has good durability, high output, uniform particle size, the general number of meshes is 40-70 mesh.
2. The dust removal efficiency of the diffuse cyclone collector can be as high as 90%. In order to prevent the dust pollution of the environment, it can also be equipped with a bag filter (2 bags).
3. the fan is 9-19, 4A and 3LW, the design air volume is 1300m/h, and the exhaust temperature is about 60.
Main technical parameters:
1. number of cutters: 1 diameter 500mm
2. screen: 1.
3. blades: 24 pieces, hardness HRC60
4. main engine speed: 3900r/min
5. main motor: model Y200L1-2 37KW, triangle edge, SPA perimeter 1800-1900, total 5 root.
6. fan: model 9-19, 4A, equipped with electric motor: model Y100L-2 3KW, vertical.
Matters needing attention in safety production:
1. Familiar with the contents of this instruction and the function of each electrical button, the rotation direction of the main engine is according to the arrow marked on the cover, and the rotation direction of the fan is checked.
2. Open the valve after the machine and the fan run normally, adjust the obliquity of the discharger, so that the machine gradually reaches the full load state, around 60A.
3. material selection requirement: the maximum size of the crusher shall not exceed 15MM. Avoid metal, stone and other errors into the machine, so as not to damage the blade and tooth plate. If there is abnormal sound during operation, check and troubleshoot immediately.
Main technical parameters Main Technical Paramter
Maintenance:
1. open the door cover regularly and check the fastening nut of the blade. If it loosened, tighten it. When the force surface of the blade is grinded to a large rounded angle after a period of use, the blade splint can be removed, and the blade can be rotated 180 degrees, which can be used after fastening.
2. Lubrication: The main engine bearings use lithium molybdenum disulfide (MOS2) grease, replacement cycle, the first 200 hours, after every 1000 hours oil injection.
3.check the inner wall of the blower and the inner wall of the wind pipe and remove the wind and dust.
kingshine plast
telephone：0510-88551090
phone：13771125771 （劉總） 13814297981（馬總）
E-mail： ceo@kingshineplast.com
Address: No,102 North Xinyou road wuxi city
Call us directly or leave a message online and we look forward to cooperating with you
